雨座AG22-2
雨座is used to determine the penetration resistance of fabrics or composites at different intensities of water impact.
read more
+86 15280858852
+86 15280858852
Schopper磨耗试验机是用来做穿抗拒ance test of textile products. The motor drives the test material tensioned on a obtuse cone to rotate, makes it contact with the friction sandpaper required by the standard, and bears the load specified by the standard to carry out the rotary friction test. This friction is continuously carried out along the bus of the cone, resulting in a friction effect in the tangent direction.
read more
Terry织物表面吸水测试仪is used for towel, face towel, square towel, bath towel, towel quilt and other towel products water absorption test.
read more
地毯可燃性测试仪用于毛皮，地毯和其他材料的易燃性和抗燃烧性能，当它们受到小火焰时。它可以用两种方式进行测试：热金属螺母方法和尿红素丸法。GydF4y2Ba
read more
11月17日，2021年GydF4y2Ba1.校准项目：角度（90°），速度（60〜100±5次/分钟）2.校正设备：角度计，电子秒表3.校准期：一年4.校准步骤：a）角度校正方法罗斯柔性电阻试验机：I。首先以水平状态调整机器。II。通过手转动电机带或按下停止和启动键调节可移动端夹具的水平位置，将角度计放在可移动夹具上，角度仪表应为0°。继续旋转腰带或按下停止和启动键移动最大夹具的最大摆动角度为90°，以观察其是否与角度计指示的值匹配。b）SATRA TM60罗斯FLEX测试仪的速度校正方法：I。启动控制面板上的电源按钮，将“PV”列重置为零，并设置“SV”列中的次数（超出校正速度的次数）。II。按开始按钮开始机器，同时让电子秒表开始定时。 iii. When the electronic stopwatch reaches 1 minute to stop timing, press the STOP machine to stop at the same time, and observe whether the 1 minute time is consistent with the standard speed. More about ROSS Flexing Tester please click: //www.40crgbanjc.com/ross-flexing-tester-af23_p88.html Contact Us Now! Sales Dept Tel: +86 15280858852 Email: sales@avenotester.com Skype: sales@avenotester.com Web: www.40crgbanjc.com
11月4日，2021年GydF4y2BaStructure Of Infrared Dyeing Fastness Test Equipment： Combined with the general advantages of infrared and traditional glycerol proofer, The use of high-temperature machine door sealant, easy to use. There is a heat transfer oil insulation function in the cage, put the cup in the next time will not be lower because of the door temperature. Dye cup material: are made of high quality SUS316. Computer Of Colorfastness Dying Machine： Microcomputer control (Chinese and English LCD computer), programmable 100 kinds of technology; A temperature rise curve, temperature accuracy of up to ± 0.1 ℃, up to 20-140 ℃. Heating and cooling rate: 0.1 ℃ ~ 9.9 ℃ / min. Electric heating Of Textile Infrared Dying Equipment: Electric heating cups and cups at the same time irradiation, power, temperature difference is small, no soot pollution, no glycerin loss; and insulation, constant temperature effect, can save huge glycerol and electricity costs. More about Infrared Laboratory Dyeing Machine please click: //www.40crgbanjc.com/infrared-laboratory-dyeing-machine-ac19_p176.html Contact Us Now! Sales Dept Tel: +86 15280858852 Email: sales@avenotester.com Skype: sales@avenotester.com Web: www.40crgbanjc.com
10月28日，2021年GydF4y2BaApplication of Fineness Tester For Fiber Fiber Content Analyzer is mainly used for measuring various fiber diameters, cross-section analysis, and content of textile ingredients. Features of Fiber Fineness Tester Obtain the longitudinal microscopic image of the fiber through the digital camera. With the intelligent assistance of the software, the operator can quickly and conveniently realize the functions of fiber longitudinal diameter test, fiber type identification, and statistical report generation. Provides an accurate scale calibration function, which fully guarantees the accuracy of the fineness test data. Provides professional automatic image analysis and fiber diameter prompt functions, making fiber diameter testing extremely easy. Provide industry standard conversion function for non-circular cross-section fibers during longitudinal testing. The fiber fineness test results and type classification data can automatically generate professional data reports or export to EXCEL tables. Suitable for fiber diameter measurement of animal fiber, chemical fiber, cotton and linen, etc., with fast measurement speed, simple operation, and reduced human error. The fineness measurement range is 2~200μm. The fiber diameter measurement meets the requirements of the national standard GB/T 10685-1989 Wool Fiber Diameter Test Method-Projection Microscope Method. The content measurement complies with the national standard GB/T 16988-1997 for the determination of the content of the mixture of special animal fiber and wool. The measurement of cotton and linen content conforms to the textile industry standard FZ/T30003-2000, the quantitative analysis method of cotton and linen blended products, and the micro-projection method. In line with the commodity inspection standard SN/T0756-1999, the quantitative analysis method and the microscope projection method for import and export hemp/cotton blended products. Provide a library of standard samples of special animal fiber and chemical fiber, which is convenient for experimenters to compare and improve the identification ability. System composition and hardware configuration of Fiber Testing Equipment (1) System software and hardware requirements: Hardware requirements: Intel dual-core 2.0 or higher processor, 512MB or more of memory, 64MB or more of display memory, 10GB or more of hard disk space, CD-ROM drive Software requirements: Chinese Windows XP or above operating system, pre-installed EXCEL2003. The system recommends the use of 17" or more color monitors, running in 1024×768 (or higher) resolution and 24-bit true color display mode. Need to adjust the computer UAC to the minimum: win+R—input MSCONFIG—tool—change UAC settings—start—adjust to the minimum. After opening the Excel option, adjust the macro security to the lowest level to prevent the system from preventing the software from performing fiber calculations and statistics. (2) Main configuration 1) System biological microscope (including CCD) 1 set...
10月18日，2021年GydF4y2Ba1 Before use, the heavy hammer must be installed in place, and the handwheel must be tightened and tightened. 2 When the Digital Elmendorf Tearing Tester is working, hands, heads, etc. should not be close to the handle turning area; it is strictly forbidden to make the handle touch any obstacles. 3 When the Tearing Tester has not been used for a long time, it should be oscillated several times before use, and the calibration operation should be carried out. 4 If you want to move the Fabric Tearing Testing machine, you must first place the swing device in a locked state. 5 There is no strong electromagnetic interference around. 6 The Paper Tearing Tester should be maintained regularly. More about Digital Tearing Tester please click: //www.40crgbanjc.com/digital-tearing-tester-ag11-3_p212.html Contact Us Now! Sales Dept Tel: +86 15280858852 Email: sales@avenotester.com Skype: sales@avenotester.com Web: www.40crgbanjc.com
Oct 04, 20211.安装两个立柱定位织物外观测量板底座和两个立柱，并将螺钉锁在底座的两侧。2.安装灯座将顶部框架与灯座定位，并在两侧锁定螺钉。3.安装面板将面板定位在面料外观测量板的顶部，对齐两侧的孔，并插入螺钉。4.安装面板支撑杆在仪器框架的两个立柱上找到两个相应的孔，并安装样品支撑框架。更多关于面料外观评估系统请点击：//www.40crgbanjc.com/fabric-appearance-assessment-system-ag47_p261.html立即联系我们！销售部门电话：+86 15280858852电子邮件：sales@avenotester.com skype：sales@avenotester.com网页：www.40crgbanjc.comGydF4y2Ba
Sep 07, 20211. First turn the speed knob (clockwise) to the minimum; 2. Place the object to be tested on the workbench and use a fixture to clamp it firmly; 3. Adjust the height of the upper and lower cross bars to make the distance between the clamps appropriate. 4. Adjust the "speed knob" to make the speed meet the requirements 5. Clamp the lower end of the test piece with the lower clamp, raise the lower cross bar to a proper distance and then stop the machine, and then clamp the upper part of the test piece with the upper clamp. 6. Turn on the Fabric Tensile Tester power, start the operation, adjust the experiment stroke, and stop after adjustment; 7. When everything is ready, press the up or down push-pull test to start the test. 8. When repeating the experiment, you can repeat the above operations. When you need to stop in the middle, you can press the stop switch, and you can continue after pressing the start; 9. After the test, adjust the displacement to the minimum and the speed to the minimum, and then turn off the power. More about the Universal Tensile Strength Tester please click: //www.40crgbanjc.com/single-column-universal-tensile-strength-tester-ag02-2_p156.html Contact Us Now! Sales Dept Tel: +86 15280858852 Email: sales@avenotester.com Skype: sales@avenotester.com Web: www.40crgbanjc.com
online service
+86 15280858852
sales@avenotester.com
sales@avenotester.com
+86 15280858852